| Card Guides |
| |
| CPCI-3U4 Series was introduced in 2000 to meet the requirements of IEEE 1101.10 and PICMG 2.0 CompactPCI specifications. The CPCI-3U4 provides a completely assembled front panel solution for the demanding peripheral designer looking to meet the stringent requirements of CompactPCI. Full EMI shielding, PCB retainers and ejector systems are supplied ready for assembly with 3U PCBs. There are no special tools or fixtures required for installation. |
 |
| |
| CPCI-2000, introduced in 2000 to meet the upgraded and stringent requirements of IEEE 1101.10 and PICMG 2.0 CompactPCI specifications. Rigid, strong and economical, CPCI-2000? provide the specification compliance and installed reliability that your most demanding rack-mounted products require. Retention is firm and there are no special tools or fixtures required for installation. Hot swap compatible, ESD grounding and IEEE 1101.10 compliant ejector. |
 |
| |
| CPCI-T Series introduced in 2000 to meet the upgraded and stringent requirements of IEEE 1101.10 and PICMG 2.0 CompactPCI specifications. Supports rear I/O and modified architectures. Rigid, strong and economical, CPCI-Ts provide the specification compliance and installed reliability that your most demanding rack-mounted products require. Retention is firm and there are no special tools or fixtures required for installation. Hot swap compatible, ESD grounding and IEEE 1101.10 compliant. |
 |
| |
| CP-xHP was introduced in 2000 to meet the requirements of IEEE 1101.10, PICMG 2.0 CompactPCI as well as VMEÆ and EUROCARD specifications. The CP-xHP provides a simple single fastener mounting method that lowers assembly cost and component count. Dual locating pins assure accurate horizontal and vertical alignment on a wide range of faceplates. There are no special tools or fixtures required for installation. |
 |
